Restoration
Bring old, small or damaged videos back to life. Restoration cleans up noise and compression, rebuilds detail and can add smooth motion. Open the Restore panel from the photo viewer, or Restore media in a Studio project’s header. Every restoration is saved as a new version, so your original file is never changed.
Choose a mode
Section titled “Choose a mode”| Mode | What it does |
|---|---|
| Faithful | Removes noise and compression while keeping the original look |
| Creative | Rebuilds fine detail and may invent texture. Best for very small sources |
| Smooth motion | Adds in-between frames for slow motion or a higher frame rate. Works on videos, from the original. See Titles and motion |
Then choose:
- Size: same size or larger, with the output capped at 4K (3840 × 2160). Frameleaf Cloud restores at 2× or 4×.
- Keep film grain to preserve fine grain instead of smoothing it.
Choose where it runs
Section titled “Choose where it runs”You pick the destination, and nothing is processed until you do. Each destination tells you whether your video stays on your network or leaves your network for this job.
Estimates come from real runs on that destination. If nothing has run there yet, it says Not measured yet. A job always stays on the destination you chose.
On Frameleaf Cloud you see an estimate and confirm before anything is sent, and the sound is never sent. See Cloud GPU.
Preview first
Section titled “Preview first”- Choose a small area: the current frame, or a crop. The preview is 5 seconds long.
- Compare before and after with a split divider and a 100% loupe.
- Choose Accept and restore to restore the whole file at full resolution with the same settings, or Reject it and try again.
Previews you haven’t reviewed are kept for 14 days, and for 7 days after you decide.
Use the restored version
Section titled “Use the restored version”A restored video appears as a version of the original. You can:
- choose Use for playback, or go back to the original
- Download restored file, or Discard it
- choose Use in Studio to add it to a project’s media beside its original
In a Studio project
Section titled “In a Studio project”Restore media in the project’s header restores a photo or video the project already uses. Choose the Photo or video, review a preview first, then accept it. The job is queued in Activity; when it’s done, choose Use in Studio to add the restored version to the project. If a restored version is later discarded or expires, Studio tells you to place the original or restore it again.
© 2026 Frameleaf Inc. All rights reserved.
Frameleaf and the Frameleaf logo are Trademarks of Frameleaf Inc.